奥林巴斯微单进工程模式查看快门次数来源：聚乐网，作者：kingkingChecking shutter count on E-p1, E-P2, E-PL1 & E-PL2By following these steps you can check your shutter count as well as a few other things. Follow these steps:1. While holding the “Menu“ button, press Power button to switch on 按住 Menu 键的同时按电源键2. Press “Menu“ and go to “Monitor brightness adjustment“ screen 按 Menu 进入菜单，进入屏幕亮度调整3. Press “Info“ and “OK“ button at same time, you will see the screen showing “Olympus“ 同时按住 Info 和 OK 键，这时你应该可以看到屏幕上显示 Olympus.4. Press the following buttons in the sequence: Up, Down, Left, Right and then press the Shutter, followed by Up (dial button in my E-P2) 按顺序按下： 上，下，左，右，快门，上，你就能进入工程菜单了5. Engineering mode page is seen. Press dial button to Page 1, 2, 3, and “D“. 通过上下左右键进入 Page1, 2, ,3, D6. Shutter count is on “Page 2“ under “R“. 其中， Page 2 的 R 显示的就是快门数。The other lines on the screen mean:R: shutter release count 快门数S: flash use count 闪光数C: CMOS cleaning mode (with mirror lock-up - in E-410 series) U: number of ultrasonic dedusting, number of power switch on 自动除尘数（相当于电源开关次数）V: number of use of LiveView 使用 Liveview 的次数B: number of shot using In-Body Stablization 使用防抖的次数Please be careful when doing this. Although its probably perfectly safe to do this i hold no responsibility if you mess up your Pen.