,WC mounting,Take out the rubber sealing rings 取出橡胶密封圈,Chisel the hole out so the pipe goes easy in 略扩孔洞尺寸以便管子容易插入,Put in the flush connection pipe and make a mark on the pipe by the end of the tile 将冲水管插到底并紧贴瓷砖面在管上作标记,Put on the rubber sealing on the flush connection pipe 在冲水管上套入橡胶圈,Put in here a photo,Put on the flush connection pipe and make a mark on the pipe by the end of the WC ceramic 装上冲水管并沿座便器边在管上作标记,Put on the waste connection pipe and make a mark on the pipe by the end of the WC ceramic 装上排水管并座便器沿边在管上作标记,Put in the waste connection pipe and make a mark on the pipe by the end of the tile 将排水管插到底并紧贴瓷砖面在管上作标记,Measure the distance X between the yellow line on the waste and flush connection pipe 量出排水管和冲水管所作标记的距离X,X,Cut from the end of the pipe the distance X on the flush and waste connection pipe 在冲水管和排水管上切除所量距离X,Take out the dirt in the pipe 清除管内脏物 Put back in the rubber sealing and put on same liquid soap 放入橡胶圈并涂抹润滑剂(肥皂水.清洁剂等),If not, file away the sharp edge 如不行,锉去锐边,Check whether the nut fit on or not 检查螺母旋入是否顺利,Prepare the plastic washer, metal washer and the nut 准备塑料垫片,金属垫片和螺母,Push in the waste and flush connection pipe 插入排水管和冲水管,Take the WC ceramic and put it on the wall 拿起座便器对准位置装在墙上,Put on on both rubber sealing same liquid soap 在橡胶圈内抹入适量润滑剂,Plastic washer 塑料垫片,2. Metal washer 金属垫片,3. Nut 螺母,Take a spirit level and level the WC ceramic 用水平尺校正座便器的水平 Then tighten with filing the nut 然后旋紧螺母,Put on the cover for the WC screw 套上螺母盖,Clean up 场地清扫,