,Safety Test 安規測試,Test Item,Insulation Resistance Test Insulation Endurance Test Leakage Current Test Inrush Current Test,Insulation Resistance Test,Aim Verify insulation strength of products (驗證產品的絕緣強度) Spec Test point: (A+B)FG Test voltage: DC500V Test time:1minute System condition: System power off Criteria Insulation Resistance: 10meg ohm,Step,Insulation Endurance Test,Aim Insulation Strength is tested using far higher than normal voltage to observe whether insulation is damaged or leakage current is too high.(以高於正常使用電壓的條件測試產品之絕緣強度,以觀察絕緣是否崩潰或洩漏電流是否過高,判定產品是否安全),Spec Test point : (A+B) FG Test voltage: AC 1.5KV(130250) AC 1.0KV(Less than130V) Test time: 1 minute System condition: System power off Criteria Leakage Current: 10mA,Step,Leakage Current,Aim Under normal voltage,simulating when body contacts product,the current is checked whether to damage the safety of body. (在正常的工作電壓下，模擬人體接觸產品時流經人體之電流量以檢視該電流量是否危害人身安全。) Spec *Test point: A FG, B FG, FGEarth,Palm RestEarth,*Input Resistance: 1.5Kohm *Input capacity: 0.15F *Input voltage: Standard voltage +10% Criteria:,Step,AC 220V,N/B之电源插座,AC Power Source,Inrush Current,Aim 驗證產品在開關暫態之電流突破是否合乎產品規格 Spec Test voltage: 100V / 230V Test frequency: 50HZ / 60HZ Trigger point: AC plug in Measure times: 5 times for each Condition: System cold,Measure Item: Inrush current: 0 to peak Lasting time: The time from the start to x1.25 with standard current value 其中x的确定为:从波形start到波形稳定时的緃坐标 之差 Criteria: Inrush Current: 52A Lasting Time: 500ms,